Bryce 30K Specifications download pdf (Page 39)

Running with the Feeder Assembly

Setting up and using the

Feed Ramp Extension

Overly long media is accommodated using the Feed Ramp

Extension, also it will perform the same functions as the

Media Support Wedge does with much shorter media.

Loosen the Locking Feeder Knob.

1. Place a piece of the media on the Feed Ramp

Assembly.

2. Turn to loosen the Feeder Locking Knob.

3. Pull the Feed Ramp Extension out from the Feed

Ramp Assembly.

4. Angle the Feed Ramp Extension up to create a

small gap between the media and the Feed Ramp

Assembly.

Pull the Feed Ramp Extension out.

5. Turn the Feeder Locking Knob to secure the

Feed Ramp Extension. Note: The gap and angle

of the Feed Ramp Extension will vary with the

type of media used. Adjust the angle of the Feed

Ramp Extension or Feed Ramp itself if the

Feeder Assembly is having difficulty consistently

supplying the printer with media.

Angle the Feed Ramp Extension up.

Revision C 30K USERS MANUAL Section 5 -7

P/N 90-00203-001

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 118 119

No comments

Bryce 30K Specifications Page 39