Bryce 30K Specifications download pdf (Page 33)

Running with the Feeder Assembly

Setting up a

feeder to

work with

the printer.

To use a feeder with the printer the setup requires two

considerations:

Use the following recommendations to help in setting up the

printer.

 Media must go through the center of the Printer

Align center of media here.

To use a feeder with the printer it is best to position the feeder

so the media travels through the center of the printer. This is

very important with small or thin media like post cards or

envelopes. Make certain the media will travel

beneath the sensor or in the path of the sensor

beam.

The media has to travel through the path of the

sensor beam for the record to be printed. This is

very important with small or thin media like post

cards or envelopes. Use the illustration to the right

for an example.

Mount the feeder to the center of the printer. The

media must interrupt the sensor beam for the printer

to know when media is being fed.

 The Entry Roller Assemblies must

take hold of the Media.

The Entry Roller Assemblies guide the

media down the Media Path.

Move the feeder close enough for the printer to

have the Entry Roller Assemblies grab the media

and guide it beneath the Print Cartridges.

The media can be sent at a slight incline or straight

into the printer.

Note: The Entry Roller Assemblies must have

control of the speed and direction of the media

otherwise poor print quality or feed errors may

occur.

Revision C 30K USERS MANUAL Section 5 -

P/N 90-00203-001

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 118 119

No comments

Bryce 30K Specifications Page 33