Bryce 30K Specifications download pdf (Page 37)

Running with the Feeder Assembly

Setting the

H-Block

Assembly

Whenever the printer will be printing on a different media

type it is necessary to re-align the spacing between the H-

Block and the rollers.

The next five steps will instruct the operator on how to

correctly adjust the H-Block spacing for printing on a

particular type of media. Readjust the thickness of the

H-Block if the printer continues experiencing misfeeds

or hesitation in feeding.

Lift lever up.

Open the Inner & Outer Fences away from the center of

the feeder.

1. Raise the Lever on the "H" Block Assembly

completely up to lift the block to the highest

position and secure in place.

Place Media under H-Block

(Shown without the Feed Ramp)

2. Manually place one piece of the media between

the separator fingers (lower section of the "H"

block) and the feed roller.

4. Release and lower the "H" Block. Let it fall

freely onto the media. When lowering the "H"

block, verify the media is between all separator

fingers and the Feed Roller.

5. Press the Lever down to secure it in place.

6. The input bin area can now be filled with the

desired media for printing. The media stack

should be "shingled" when loaded into the input

bin with flap facing downward. Start with just a

few envelopes to start the stack and get the

proper contour then add more pieces.

Press lever down.

• Post cards - set a smaller gap between the

separators and feed roller, by using standard copy

paper (.003" [0.076 mm] thickness).

• Stuffed Media - set a larger gap between the

separator blocks and the feed roller, by adding two or

three, number ten (# 10) envelopes, on top of the

media before setting the separators

Hint: If you are experiencing

feeding problems using post cards

or stuffed media. Try out the

suggestions listed for Post cards,

Stuffed Media and Magazines &

Booklets.

Revision C 30K USERS MANUAL Section 5 -

P/N 90-00203-001

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 118 119

Comments to this Manuals

No comments

Bryce 30K Specifications Page 37

Comments to this Manuals